Hardware ID

Discussion in 'General Questions' started by jhursh, Jan 16, 2011.

  1. jhursh

    jhursh Bit poster

    Messages:
    1
    Hi,
    I have a PC and a MAC with Parallels. I was wondering if there was a way to modify the Hardware ID of a VM. I have software that is licensed that way but want to be able to run it in a VM from either machine.

    thx

    Jim
     
  2. tho-bln

    tho-bln Bit poster

    Messages:
    2
    Hello,

    I have the same problem. When I changed some settings in Parallels Desktop 7 for Mac I get a new hardware ID. Afterwards some of my software programs I used on Parallels need a new activation. I do not know why. The producer limited the amount of activations. Thats bad. Now I cannot use few programs and I have to wait for their acceptance.

    If there exists a way to change or reset the hardware ID to default version I would beg you to comment.

    Many thanks in advance for your help.

    Greetings,

    Thorsten
     
  3. James DonovanJ

    James DonovanJ Junior Member

    Messages:
    13
    Same problem occur in my PC.. What i can do????
     
  4. tho-bln

    tho-bln Bit poster

    Messages:
    2
    Nobody give us help ... :(

    Hey, I didn't get any help in this Forum. Also Parallels doesn't help. I think Parallels isn't interisting in our problems with their software.

    If you get a solution pls inform me. Many thanks.

    Best regards
     

Share This Page