Parallels 5 Not Switching To Crystal or Coherence

Discussion in 'Windows Virtual Machine' started by SayleM, Feb 16, 2011.

  1. SayleM

    SayleM Bit poster

    Messages:
    1
    I am running Parallels 5 Build 9376 which is the latest I believe.

    About a week ago I was able to switch my Windows 7 64-bit VM to Crystal and Coherence mode on my 2006 Mac Pro. I restarted it and since then every time I try to switch to Crystal or Coherence it makes the error beep and freezes the machine for about 2 seconds then pops up a message saying it cannot switch to the mode please try again later or contact Parallels support.

    I did nothing at all except restart inside the VM and have tried to reinstall Parallels Tools in the VM. It has done absolutely nothing to help.

    Has anybody seen this and have a solution? I was considering upgrading to 6 but if the software is going to start acting like this all of a sudden I will not upgrade and just go VMWare for my future VM needs.
     

Share This Page