hello. Using Parallels Desktop7 (Build 7.0.15055, Revision 740667; March 5, 2012), and created a Fedora 15 vm, using the "Download Fedora Free" built-in wizard instead of manually grabbing an .iso, etc. (this is *more* supported, right? everything works, except some code which is expecting "eth0", while i have: nharkins@fedora:~$ ifconfig -a eth2 Link encap:Ethernet HWaddr 00:1C:42:6C:B1:B9 inet addr:10.211.55.3 Bcast:10.211.55.255 Mask:255.255.255.0 inet6 addr: fdb2:2c26:f4e4:0:21c:42ff:fe6c:b1b9/64 Scope:Global inet6 addr: fe80::21c:42ff:fe6c:b1b9/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:715390 errors:0 dropped:0 overruns:0 frame:0 TX packets:176424 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1001924290 (955.5 MiB) TX bytes:11736142 (11.1 MiB) nharkins@fedora:~$ ls -l /etc/sysconfig/network-scripts/ifcfg-eth* -rw-r--r--. 1 root root 106 Jun 6 2011 /etc/sysconfig/network-scripts/ifcfg-eth0 nharkins@fedora:~$ cat /etc/sysconfig/network-scripts/ifcfg-eth0 IPV6INIT="yes" NM_CONTROLLED="yes" HWADDR="00:1C:42:A9:5D:63" BOOTPROTO="dhcp" DEVICE="eth0" ONBOOT="yes" why do i only have eth2? especially when there is config for "eth0"?