Cannot activate after hardware repair

Discussion in 'Installation and Configuration of Parallels Desktop' started by westhomas, Apr 15, 2014.

  1. westhomas

    westhomas Bit poster

    Messages:
    4
    My Macbook Pro was in the shop and received a new logic board. Upon reopening Parallels it requests an activation but says I have reached my maximum number of activations.

    I've used one of my email support cases, but haven't heard back and it's been almost 24 hours.

    Please help!
     
    westhomas, Apr 15, 2014
    #1
  2. Maheesh@Parallels

    Maheesh@Parallels Parallels Support Parallels Support

    Messages:
    406
    Hello westhomas,

    Please check your private message.
     
    Maheesh@Parallels, Apr 22, 2014
    #2
  3. CarlesL

    CarlesL Bit poster

    Messages:
    1
    Same problem

    I have the same problem mentioned here.
    Can anyone help me with the solution ?

    Thank you
     
    CarlesL, Apr 30, 2014
    #3
  4. Manojkumar@Parallels

    Manojkumar@Parallels Parallels Support

    Messages:
    124
    Hi CarlesL,

    Please check your private message to assist you better.
     
    Manojkumar@Parallels, May 6, 2014
    #4

Share This Page