BUGCODE_USB_DRIVER BSOD with Chipcon CC2400EB

Jun 16, 2007, 12:47 PM #1
Jisi Member Join: Mar 2006 Posts: 57	BUGCODE_USB_DRIVER BSOD with Chipcon CC2400EB I understand that htis might be somewhat "obscure" Hardware but it is really annoying. I tried using a Chipcon (now) Evaluation kit for their RF transceivers and which connects via USB to the PC. http://www.chipcon.com/files/CC2420_...Manual_1_0.pdf I was able to install drivers under Parallels (4128), but whenver I run their included packetsniffer applicaton I get a BSOD with "BUGCODE_USB_DRIVER" Parallels wonky USB support is really a bit annoying when doing embedded development (If you search this forums you'll see that I also whined about bad JTAG adapter support). I'd really appreciate stable USB support for devices besides mass storage. Ok some information from Apples System profiler: Code: CC2400EB: Version: 24.20 Bus-Strom (mA): 500 Geschwindigkeit: Bis zu 12 MBit/s Hersteller: Chipcon Produkt-ID: 0xeb11 Hersteller-ID: 0x11a0 Find USBProber information in attached screenshot. The board uses an Cypress EZ-USB FX for USB connectivity if that is of any relevance. Any ideas how I can get this to work?

Jun 16, 2007, 12:47 PM

Jisi
Member

Join: Mar 2006
Posts: 57

BUGCODE_USB_DRIVER BSOD with Chipcon CC2400EB

I understand that htis might be somewhat "obscure" Hardware but it is really annoying. I tried using a Chipcon (now) Evaluation kit for their RF transceivers and which connects via USB to the PC.
http://www.chipcon.com/files/CC2420_...Manual_1_0.pdf
I was able to install drivers under Parallels (4128), but whenver I run their included packetsniffer applicaton I get a BSOD with "BUGCODE_USB_DRIVER"

Parallels wonky USB support is really a bit annoying when doing embedded development (If you search this forums you'll see that I also whined about bad JTAG adapter support). I'd really appreciate stable USB support for devices besides mass storage.

Ok some information from Apples System profiler:

Code:

CC2400EB:

  Version:	24.20
  Bus-Strom (mA):	500
  Geschwindigkeit:	Bis zu 12 MBit/s
  Hersteller:	Chipcon
  Produkt-ID:	0xeb11
  Hersteller-ID:	0x11a0

Find USBProber information in attached screenshot.

The board uses an Cypress EZ-USB FX for USB connectivity if that is of any relevance.

Any ideas how I can get this to work?

« Previous Thread | Next Thread »

Search this thread	Forum jump
Advanced Search

Thread tools	Display modes
Printable Version Email this Page	Linear Mode Hybrid Mode Threaded Mode

Parallels Technology Network

BUGCODE_USB_DRIVER BSOD with Chipcon CC2400EB