Parallels 3150 RC2 & Nokia USB

Feb 13, 2007, 05:26 PM #1
stefan_eb Junior Member Join: Feb 2007 Posts: 1	Parallels 3150 RC2 & Nokia USB Hi, today I wanted to test the Nokia firmware upgrade application (1.3.0) within a WinXP Pro setting of Parallels (iMac Core2Duo with 10.4.8). Software installation works fine. I connect my E61 via USB and manually activate the device via the USB button/Popup menu. Device is connected, drivers are being loaded. I start the Nokia Software (Firmware) Update application. It connects to the phone and checks the firmware status via internet. So far so good. I decided to cancel the offered upgrade and end the application. The result is a complete crash of Parallels (simply vanishes). An Apple notification that an error has occurred is shown and if I want to send a crash report. The error can be reproduced. Any ideas? Kind Regards, Stefan

Feb 13, 2007, 05:26 PM

stefan_eb
Junior Member

Join: Feb 2007
Posts: 1

Parallels 3150 RC2 & Nokia USB

Hi,

today I wanted to test the Nokia firmware upgrade application (1.3.0) within a WinXP Pro setting of Parallels (iMac Core2Duo with 10.4.8). Software installation works fine. I connect my E61 via USB and manually activate the device via the USB button/Popup menu. Device is connected, drivers are being loaded. I start the Nokia Software (Firmware) Update application. It connects to the phone and checks the firmware status via internet. So far so good. I decided to cancel the offered upgrade and end the application. The result is a complete crash of Parallels (simply vanishes). An Apple notification that an error has occurred is shown and if I want to send a crash report. The error can be reproduced. Any ideas?

Kind Regards,

Stefan

« Previous Thread | Next Thread »

Search this thread	Forum jump
Advanced Search

Thread tools	Display modes
Printable Version Email this Page	Linear Mode Hybrid Mode Threaded Mode

Parallels Technology Network

Parallels 3150 RC2 & Nokia USB