Unable To Connect to Hypervisor - NO MATTER WHAT I DO

Discussion in 'Parallels Desktop for Mac' started by giatjay, Oct 10, 2006.

  1. giatjay

    giatjay Bit poster

    Messages:
    1
    I don't get it, this should be so easy. I Followed all instructions, Tried both ISO and XP SP2 install disk (2 different ones) and all that I get is "Unable To Connect to Hypervisor " whenever I try to start the darned thing. I tried the sleep method too and no luck.

    I am runing on a Mac PRO dual 2.66
    1gb ram

    Fresh out of the box.

    Thanks in advance for and suggestions/solutions.
     
    giatjay, Oct 10, 2006
    #1
  2. stu

    stu Bit poster

    Messages:
    5
    Same set up, same problem -- c'mon Parallels, there must be a fix for this!
     
    stu, Oct 10, 2006
    #2
  3. nosodualie

    nosodualie Member

    Messages:
    27
    You guys need the updated version of parallels, build 1922 RC 2 eEmail tech support or look around in the forums for a link to the download.
     
    nosodualie, Oct 10, 2006
    #3
  4. joem

    joem Forum Maven

    Messages:
    1,247
    Download the latest build from http://download.parallels.com/stuff/Parallels-Desktop-1940-Mac-en.dmg and install it. Reboot your Mac, and then try it.
     
    joem, Oct 10, 2006
    #4
  5. stu

    stu Bit poster

    Messages:
    5
    I just got a patch from Parallels support that fixed the problem -- good response -- less than 12 hours.
     
    stu, Oct 11, 2006
    #5

Share This Page