Parallels runs Axis CCTV fully

Discussion in 'Installation and Configuration of Parallels Desktop' started by Tim Powys-Lybbe, May 26, 2013.

  1. Tim Powys-Lybbe

    Tim Powys-Lybbe Bit poster

    Messages:
    1
    I have long been a Mac user. I bought an Axis CCTV as I had been told it would run on a Mac. This was true apart from one feature, setting up motion detection, which absolutely required a PC. I assumed that I could do this under my emulation program, V*M*a*e F*s*o*. However this was not possible, not even with lengthy support from Axis themselves. Eventually someone suggested I try Parallels and immediately the Axis feature ran OK, as does an optional monitoring program. I contacted V*M*a*e F*s*o* and they were able, over some remote link to my machine, to replicate the fault. But they have not been able to resolve it. So I have now bought Parallels. Thanks, everybody at Parallels!

    Tim Powys-Lybbe
     

Share This Page