After using a parallels 10 for a day I encountered two problems that bothered me quite a bit: 1) the back/foward arrow buttons on windows are extremely small and thus very hard to see. Does anyone know how to change the size of the buttons? 2) the language conversion using command button is very laggy; on a normal/ non virtual windows 7, the language conversion was almost instantaneous whereas on the virtual machine I need to wait about a second for it to convert into a different language. Because I was used to the instant conversion on a real windows 7, when I pressed command button and started writing immediately expecting the language to have changed instantaneously, language conversion failed meaning during that one second when the virtual machine converts the language you must not start writing otherwise the conversion fails. Does anyone know why this happens? Thanks
After using a parallels 10 for a day I encountered two problems that bothered me quite a bit: 1) the back/foward arrow buttons on windows are extremely small and thus very hard to see. Does anyone know how to change the size of the buttons? 2) the language conversion using command button is very laggy; on a normal/ non virtual windows 7, the language conversion was almost instantaneous whereas on the virtual machine I need to wait about a second for it to convert into a different language. Because I was used to the instant conversion on a real windows 7, when I pressed command button and started writing immediately expecting the language to have changed instantaneously, language conversion failed meaning during that one second when the virtual machine converts the language you must not start writing otherwise the conversion fails. Does anyone know why this happens? Thanks
