Recreate Parallels network interface in Mac

Discussion in 'Installation and Configuration of Parallels Desktop' started by adecold, Oct 2, 2008.

  1. adecold

    adecold Bit poster

    Messages:
    2
    I accidentally deleted the parallels network interface on the mac network configuration. I use multiple locations and parallels had the interface only installed on one location.

    How do i recreate the parallels network interfaces in mac os x without having to re-install parallel?

    Thanks
    Tutu
     
  2. John@Parallels

    John@Parallels Forum Maven

    Messages:
    6,333
  3. adecold

    adecold Bit poster

    Messages:
    2
    If i choose to re-install, how can i install the parallels interfaces on multiple locations within mac os x?
     
  4. itsdapead

    itsdapead Hunter

    Messages:
    177
    You should be able to do this from the "Network" panel under system preferences.

    Choose your location then, where it says "Show:" choose "Network Port Configurations" from the drop-down.

    You should see a list of available network ports with checkboxes - including "Parallels NAT" and "Parallels Host-Guest".
     

Share This Page