Stuck in Startup Repair

Discussion in 'Installation and Configuration of Parallels Desktop' started by MichaelM6, Jun 4, 2015.

  1. MichaelM6

    MichaelM6 Bit poster

    Messages:
    1
    Hi,

    I was trying to transition over my PC as a virtual machine to my mac, and the data transfers, however when trying to startup my virtual machine, it goes automatically to startup repair, and it can not repair. The specific error occurs when it is "preparing to configure my virtual machine", and the windows error is attached below.

    Thanks!
     

    Attached Files:

    MichaelM6, Jun 4, 2015
    #1
  2. Dishant@Parallels

    Dishant@Parallels Parallels Support

    Messages:
    234
    Hi MiCHAELm6,
    Could you please go through the Knowledge based article given below and check if you can get this issue resolved.
    http://kb.parallels.com/5223
     
    Dishant@Parallels, Jun 5, 2015
    #2

Share This Page