Unable to view all files in software

Discussion in 'Installation and Configuration of Parallels Desktop' started by Sylviao, Mar 15, 2013.

  1. Sylviao

    Sylviao Bit poster

    Messages:
    1
    I have an embroidery program that is not recognizing all the files I've copied from a PC. I'm using the same Windows 7 and Embroidery software but with the Parallels 8/Windows 7 only some of the files can be seen via the program, but on the PC i was able to see all of them. Yet when I go thru computer/c drive ( on the Mac) I can see all the files.
    Would appreciate any suggestions.
     
    Sylviao, Mar 15, 2013
    #1

Share This Page