VM Conversion to PD 4.0 issue

Discussion in 'Installation and Configuration of Parallels Desktop' started by poiesis, Dec 19, 2008.

  1. poiesis

    poiesis Bit poster

    Messages:
    1
    I have installed PD 4.0 and started the conversion of my Vista VM. Toward the end of the conversion PD said I had to switch to manual mode. When attempting to logon to Vista VM to finish the conversion the logon name was switched to __ParallelsHelper0. The original logon was on a windows domain. I am now unable to logon to the Vista VM any ideas on how to fix this?
     
    poiesis, Dec 19, 2008
    #1
  2. John@Parallels

    John@Parallels Forum Maven

    Messages:
    6,333
    The problem is that you will not be able to login to domain, without network, but network will be available in Vista only after Parallels Tools installation, solution is to login using local admin account, and install Parallels Tools,
    or remove VM from domain prior to upgrade to version 4
     
    John@Parallels, Dec 20, 2008
    #2

Share This Page