WindowsXP VM to Mac VM

Discussion in 'Installation and Configuration of Parallels Desktop' started by antzinoz, Feb 8, 2011.

  1. antzinoz

    antzinoz Bit poster

    Messages:
    1
    Hi All - just looking for some advice. Have a client who's created a WindowsXP VM using the Win version of Parallels to be used in the mac version. Transferring the VM was fine, but when opening on the Mac I see the 'Unable to connect to Hard Disk 1' error.
    I'm relatively new to Parallels, but have checked the obsvious things like permissions etc. Is there any things that I should be looking at.

    Thank you in advance.
     
    antzinoz, Feb 8, 2011
    #1
  2. mH2

    mH2 Member

    Messages:
    33
    Don't know if this helps, but I noticed that the VM saw my SATA drive as IDE0:0 and the DVDROM as IDE0:1
    Check the Hardware tab in Configuration...
    and experiment.
     
    mH2, Feb 8, 2011
    #2

Share This Page