BUGCODE_USB_DRIVER BSOD with Chipcon CC2400EB

Discussion in 'Parallels Desktop for Mac' started by Jisi, Jun 16, 2007.

  1. Jisi

    Jisi

    Messages:
    57
    I understand that htis might be somewhat "obscure" Hardware but it is really annoying. I tried using a Chipcon (now) Evaluation kit for their RF transceivers and which connects via USB to the PC.
    http://www.chipcon.com/files/CC2420_ZigBee_DK_User_Manual_1_0.pdf
    I was able to install drivers under Parallels (4128), but whenver I run their included packetsniffer applicaton I get a BSOD with "BUGCODE_USB_DRIVER"

    Parallels wonky USB support is really a bit annoying when doing embedded development (If you search this forums you'll see that I also whined about bad JTAG adapter support). I'd really appreciate stable USB support for devices besides mass storage.

    Ok some information from Apples System profiler:
    Code:
    CC2400EB:
    
      Version:	24.20
      Bus-Strom (mA):	500
      Geschwindigkeit:	Bis zu 12 MBit/s
      Hersteller:	Chipcon
      Produkt-ID:	0xeb11
      Hersteller-ID:	0x11a0
    
    Find USBProber information in attached screenshot.
    [​IMG]

    The board uses an Cypress EZ-USB FX for USB connectivity if that is of any relevance.

    Any ideas how I can get this to work?
     

Share This Page