Build 5160 and Leopard

J

jasdelta

Bit poster
Hi Folks,

Under 10.4.10, when starting up 5160 and my VM the screen would open and immediatly start up my XP Home VM. And on shutdown everything would also close, including Parallels 3.0. Now with Leopard 10.5 installed Parallels starts up then sits there on the screen, until I push the green startup button. Then it will startup and runs normally. On shutdown the VM closes but only to the Parallels startup screen again, but will not totally quit as it did in 10.4.10.

Has this issue been reported yet?

Jim
 
jasdelta said:
Hi Folks,

Under 10.4.10, when starting up 5160 and my VM the screen would open and immediatly start up my XP Home VM. And on shutdown everything would also close, including Parallels 3.0. Now with Leopard 10.5 installed Parallels starts up then sits there on the screen, until I push the green startup button. Then it will startup and runs normally. On shutdown the VM closes but only to the Parallels startup screen again, but will not totally quit as it did in 10.4.10.

Has this issue been reported yet?

Jim
Click to expand...

Did you check the action settings in your General Preferences in Parallels?

Steve
 
You must log in or register to reply here.
Back
Top