My system:
- MacMini 2012
- OSX Sierra 10.12.2
- Guest: Linux CentOS 6.8
Virtual Macchine always run 100% cpu in OSX Monitor but if run monitor on Linux Guest (top command) I dont' see any procces at 100% cpu use.
With 100% I mean 100% on evry cpu assigned to a VM, so if there are 2 cpu on monitor there is 200% cpu use, 4 cpu 400% ecc
This vm works fine for weeks, but in the last three days starts this strange behavior.
I tryed this guide (http://kb.parallels.com/en/116263) already but without success, if I run old disk with new vm I have same issue.
I tryed also:
- switch hypervisor (Parallels/Hypervisor)
- change performance setting in optimization tab
- clone vm
- chnege number of process allocation
Notthing solve the iusse.
I hope someone could help me.
Thanks
- MacMini 2012
- OSX Sierra 10.12.2
- Guest: Linux CentOS 6.8
Virtual Macchine always run 100% cpu in OSX Monitor but if run monitor on Linux Guest (top command) I dont' see any procces at 100% cpu use.
With 100% I mean 100% on evry cpu assigned to a VM, so if there are 2 cpu on monitor there is 200% cpu use, 4 cpu 400% ecc
This vm works fine for weeks, but in the last three days starts this strange behavior.
I tryed this guide (http://kb.parallels.com/en/116263) already but without success, if I run old disk with new vm I have same issue.
I tryed also:
- switch hypervisor (Parallels/Hypervisor)
- change performance setting in optimization tab
- clone vm
- chnege number of process allocation
Notthing solve the iusse.
I hope someone could help me.
Thanks