Key Commands?

Discussion in 'Parallels Desktop for Mac' started by wilder13, Apr 29, 2006.

  1. wilder13

    wilder13

    Messages:
    3
    Since I started using Parallels (beta 1), I get to a point in Windows where typing a key will trigger a command to happen (i.e. "m" hides the current window and "r" brings up the Run window). I thought I had done something in Windows that I couldn't find, so I installed a fresh copy of Windows in a new VM hard drive, but the same thing happened.

    Shutting down Windows and restarting makes the issue go away...for a few minutes.

    Is this a WIndows setting that I'm missing, or is something wrong? This one is driving me nuts.

    Any help would be greatly appreciated.

    -=B=-
     
  2. gary

    gary Bit Poster

    Messages:
    37
    I get this problem a lot too. It seems like the windows key is getting stuck. Pressing cmd a few times usually fixes it. Maybe being able to disable the windows key would help?

    I think there's a registry entry for it. I'm going to try it out.
     

Share This Page