Parallels Hangs when I change network Locations

K

kremu

Bit poster
In one network location I have the following config

Airport - Active
Ethernet - Action

In the other location

Airport - Active
Ethernet - Inactive

When switch between the two Parallels hangs and shows not responding. Any one else have this issue? Or know how to resolve it?

Thanks,

Remy
 
Try suspending the VM first, then switch locations...

It's a complicated little procedure given the Parallels virtual adaptors and stuff have to be reset to the new config.

If suspending works (doesn't crash Parallels), but you have no network connectivity - you might need to release/renew your DHCP lease on the VM.

good luck!
 
You must log in or register to reply here.
Back
Top