[PD10] can't connect to bootcamp, tried manual approach, bootcamp partition not displayed

Discussion in 'Installation and Configuration of Parallels Desktop' started by HanC, Nov 20, 2015.

  1. HanC

    HanC Bit poster

    Hi PD Community,
    I just used bootcamp to install a fresh copy of Windows 10 EDU and I want to connect to it via PD10.
    However the bootcamp option wasn't display so i've tried to solution proposed here (http://kb.parallels.com/en/112941)
    However when it comes to selection the partition i can't select the bootcamp partition. The Bootcamp partition is displayed both via Disk Utility and Terminal.
    Any suggestions? :)

    Thanks a lot!

    Screenshot 2015-11-20 19.28.46.png
  2. Sylvester@Parallels

    Sylvester@Parallels Parallels Support

    Hello HanC, Please follow this article to detect Windows 10 Boot camp Partition.

Share This Page