problems with Parallels and Update Mac OS X 10.4.10

Discussion in 'Installation and Configuration of Parallels Desktop' started by blekm, Jun 22, 2007.

  1. blekm

    blekm Member

    Messages:
    39
    i've install the update Mac OS X 10.4.10.

    After this, I can't connect anything via usb on Windows.
    The messagge from Parallels is this:

    USB device you are trying to connect to the virtual machine is being used by another application. Close that application or unplug the device and plug it again. Then try to connect the device again.

    before 10.4.10 the usb device works good.

    Some ideas?
     
  2. phantomo

    phantomo Bit poster

    Messages:
    2
  3. blekm

    blekm Member

    Messages:
    39
    ok, I'll wait some days for the fix. :)

    Where you write when the fix is already? :D
     
  4. DrivinWest

    DrivinWest Bit poster

    Messages:
    2
    I'm waiting for the next build before I install Parallels. I just put a clean copy of OS X on my machine and updated it to 10.4.10. Boot Camp 1.3 is installed with Vista on a 32GB partition. Everything works. The last thing I need is Parallels' incompatibility with 10.4.10 to screw it all up :p
     
  5. fbronner

    fbronner Pro

    Messages:
    384
    I did the update to 10.4.10. I do not use bootcamp, but everything works fine.
     
  6. blekm

    blekm Member

    Messages:
    39
    you don't have my problem with Parallels? Which version you have? I have the latest, before the last update... I don't remember my Parallel's version.
     
  7. jackybe67

    jackybe67 Pro

    Messages:
    467
    there are no problems with 3.0, only 2.5

    Parallels is working to fix it in 2 days.
     
  8. ajay

    ajay Hunter

    Messages:
    153
    The fix is out for 2.5, it's build 3214. It eliminates the USB problems.
     
  9. blekm

    blekm Member

    Messages:
    39
    3214? I don't remember my version.. where is this fix? :)
     
  10. ajay

    ajay Hunter

    Messages:
    153
  11. blekm

    blekm Member

    Messages:
    39
  12. masonjames

    masonjames Junior Member

    Messages:
    19
    Yes Blekm, you can install it right over your old version of parallels, I did this a couple days ago and it installed with the parallels tools just fine. It's just an update to 2.5. No more USB problems!
     

Share This Page