Upgrade key needs original activation key

Discussion in 'Installation and Configuration of Parallels Desktop' started by hack101, Jun 22, 2007.

  1. hack101

    hack101 Junior Member

    I had originally purchased 2.5, then became a member of the beta program. I purchased a 3.0 upgrade which I applied to a 3.0 beta installation which itself was an upgrade from 2.5. Everything was working fine.

    Following some gremlins with 10.4.10 I've hosed the hard disk and installed a clean copy of Tiger. Now I'm trying to get build 4128 working but it is asking for the key from the version I upgraded from (presumably the 2.5 copy).

    I can't find the activation email from my original purchase. Is there any way to either send me a 2.5 key or a 'full' 3.0 key?


    Peter Glock
  2. Ankou

    Ankou Guest

    Please check you Private Messages
  3. hack101

    hack101 Junior Member

    Superb support. That did the trick.

    Thank you.
  4. SnakeDiver

    SnakeDiver Member

    Wish I could get support like this from Parallels :(

Share This Page