Autocad 2004 Mouse Behaviours

P

palba

Bit poster
Hi All,
I'm an autocad user. I'm using version 2004 that worked perfect on my previous old PC.
On Parallels build5584, it's quite unusable. Moving the mouse on the draw result slow and not so precise.
What can I do? Could I change some setting to get a better autocad performance?
Thanks in advance
Paul
 
Not yet! I have to confess that the Italian version is still at 5582. I've been make a small mistake, hopefully parallels would release the italian version very soon..
However, I just did some trick that helped a little:
I've choosen the higher possible video ram in the parallels tools setting,
than in the pc i've set, in display setting, not the maximum graphics performance.
It's seem quite better but I would try to reinstall the parallels tools as you suggest.
Tanks
Paul
 
HI,

THIS MAIL IS JUST TO ANNOUNCE THAT TODAY I'VE TAKEN THE DECISION TO USE ANOTHER APPLICATION TO DO THE JOB.
Parallels is not so heavy yet.
I've done my best to let it work. But I don't think that a mac user, especially a switcher,
don't need to do a lot of thing to let the things works.
I'm sorry guys.
I'm gone.
Bye
Paul
 
Hello,

sorry for inconvenience. We were investigating this issue.

To overcome this issue it is needed to ctrl-click on the Windows Desktop, select "Properties" in drop-down menu, go to "Settings" tab, click "Advanced" and then "Troubleshoot" tab.
After that it is needed to move "Acceleration" slider - select one less than full.

Best regards,
Stacey
 
You must log in or register to reply here.
Back
Top