Hello everybody. I use a Honeywell MS9540 barcode scanner and have the following problem.
Sometimes the scanner works fine, sometimes the scanner does not pass the control characters (in German "Steuerzeichen".
An example would be that the scanner should actually recognize the following characters: "^B$$00001-WS"
However, it recognizes only "$$00001-WS" This does not execute the correct function in the program used.
Why it sometimes works and sometimes not, I can not explain.
In Parallels is of course set that the USB device is connected directly into Windows 10. Can someone help me with the problem?
With best regards
Guido
Sometimes the scanner works fine, sometimes the scanner does not pass the control characters (in German "Steuerzeichen".
An example would be that the scanner should actually recognize the following characters: "^B$$00001-WS"
However, it recognizes only "$$00001-WS" This does not execute the correct function in the program used.
Why it sometimes works and sometimes not, I can not explain.
In Parallels is of course set that the USB device is connected directly into Windows 10. Can someone help me with the problem?
With best regards
Guido