BSOD when resuming my Win10 VM from sleep

B

buckZor

Bit poster
So this is a new annoyance. I have zero issues with my VM unless I sleep it and then attempt to resume it. Mac Pro Edition, v14.1.0 (45387). My VM is intended to be a very secure VM, it's Windows 10 v1809 with Secure Boot. I do have Encryption enabled on this VM. Any ideas?

BSOD is Stop code: KERNEL SECURITY CHECK FAILURE
 
buckZor said:
So this is a new annoyance. I have zero issues with my VM unless I sleep it and then attempt to resume it. Mac Pro Edition, v14.1.0 (45387). My VM is intended to be a very secure VM, it's Windows 10 v1809 with Secure Boot. I do have Encryption enabled on this VM. Any ideas?

BSOD is Stop code: KERNEL SECURITY CHECK FAILURE
Click to expand...
Hi, did you try these instructions?
If not, please check, try and let us know the results
 
Yes, I have completed all the steps listed there. The Memory Diagnostic was a good tip, hadn't done that yet. All comes back clean. Again, this VM is very stable, this only happens when resuming from Sleep. I am suspect that it's a Parallels setting in conflict?
 
buckZor said:
Yes, I have completed all the steps listed there. The Memory Diagnostic was a good tip, hadn't done that yet. All comes back clean. Again, this VM is very stable, this only happens when resuming from Sleep. I am suspect that it's a Parallels setting in conflict?
Click to expand...
Ok, got you. Could you generate the problem report please? Check this article for more info about the report.
Please generate it right after the issue reproduced and reply us back with the report ID.
 
You must log in or register to reply here.
Back
Top