DC++, Revconnect & Active mode problem

R

roof

Bit poster
Why revconnect, dc++, strongdc etc does not work in active mode???
With Shakespeer on mac i don't have any problems with active mode (but there some other bugs). So do i need change guest ip or something else to get active mode? Thanx
 
Hello!
Please try changing to virtual adapter type to Bridged Ethernet. To do this, open the VM's Configuration Editor and locate the Network Adapter section.
See if this helps, thanks!
 
.... well, i have cable modem connection. In Crossover i have installed revconnect and it was working in active mode. In Parallels i used shared networking, but after i set Bridged Ethernet internet connection was lost.
In Network settings Built-in Ethernet has one adress, Parallels Host Guest different, and Parallels Nat too has a different adress. And they all Using DHCP...

I hope it was usefull
 
You must log in or register to reply here.
Back
Top