My iMac's internal hard drive recently failed, and we had it replaced with a new SSD drive.
Luckily we had a backup of the .pvm file just a few days old.
We put the .pvm file onto the new SSD along with the rest of the old Mac files from a Time Machine backup.
Starting the Virtual Machine however gives the error "Cannot connect to Hard Disk 0", and shows the windows black and white boot screen behind it. After a few seconds a 2nd error appears "There is no Operating System Installed on this Virtual Machine"...
Tried re-installing Parallels 10, but just get the same error message. In Hardware settings the Hard Disk "Connected" check box is un-ticked, tried checking it but it just un-checks itself after another boot up.
Anyone have any suggestions?
Luckily we had a backup of the .pvm file just a few days old.
We put the .pvm file onto the new SSD along with the rest of the old Mac files from a Time Machine backup.
Starting the Virtual Machine however gives the error "Cannot connect to Hard Disk 0", and shows the windows black and white boot screen behind it. After a few seconds a 2nd error appears "There is no Operating System Installed on this Virtual Machine"...
Tried re-installing Parallels 10, but just get the same error message. In Hardware settings the Hard Disk "Connected" check box is un-ticked, tried checking it but it just un-checks itself after another boot up.
Anyone have any suggestions?
