Still cannot get any of my Garmin GPS hardware units to work with Mapsource or Training Center. The device is recognized by Windows XP and loads the appropriate drivers. When looking in the Device Manager control panel the units are again recognized. The Garmin software does not however see the units. Anyone able to get this to work??
Garmin and Parallels Desktop for Mac Beta 3120
- Thread starter hmbmd
- Start date
(utter disappointment)slboettcher
Junior Member
Nüvi 660 works fine...
With 3120, my Nüvi 660 is working great.
Scott
With 3120, my Nüvi 660 is working great.
Scott
Forerunner 305
Isn't working either, which is a shame as I upgraded from a non working Polar (using IR) to what I hoped would be a more stable setup with a USB connection....
It appears in the list of USB devices as "Garmin International - Garmin International" and Parallels thinks it can connect, I even get the new hardware sound in Windows, but that's as far as it goes.
Selecting "Add New Hardware" starts the wizard and in the list of devices it shows "Garmin USB GPS" it then says the device is working properly....
Although I'd certainly argue the point....
Any suggestions ?
Isn't working either, which is a shame as I upgraded from a non working Polar (using IR) to what I hoped would be a more stable setup with a USB connection....
It appears in the list of USB devices as "Garmin International - Garmin International" and Parallels thinks it can connect, I even get the new hardware sound in Windows, but that's as far as it goes.
Selecting "Add New Hardware" starts the wizard and in the list of devices it shows "Garmin USB GPS" it then says the device is working properly....
Although I'd certainly argue the point....
Any suggestions ?