Having installation/access issue with Parallels 12 after updating Mojave

Discussion in 'Installation and Configuration of Parallels Desktop' started by TaehwanS, Jun 17, 2018.

Tags:
  1. TaehwanS

    TaehwanS Bit poster

    Messages:
    1
    It keeps saying that I should 'click allow' from system preferences, but the problem is, 'allow button' is not showing on system preferences.
    I thought it might be just something going wrong, so I clean-uninstalled parallels via appzapper and re-installed it. Still, same message, same error, no access.

    What should I do? Should I update to parallels 13? If so, when would parallels 14 come?
     
    TaehwanS, Jun 17, 2018
    #1
  2. PaulChristopher@Parallels

    PaulChristopher@Parallels Product Expert Staff Member

    Messages:
    3,158
    Hi @TaehwanS, you can try disabling System Integrity Protection and check if you can use Parallels Desktop.
    please follow these steps to disable SIP:
    1. Restart your Mac.
    2. Before OS X starts up, hold down Command-R and keep it held down until you see an Apple icon and a progress bar. Release. This boots you into Recovery.
    3. From the Utilities menu, select Terminal.
    4. At the prompt type exactly the following and then press Return: csrutil disable
    Terminal should display a message that SIP was disabled.
    5. From the menu, select Restart.
    6. You can re-enable SIP by following the above steps, but using csrutil enable instead.
     
    PaulChristopher@Parallels, Jun 17, 2018
    #2

Share This Page