I am New to Parallels and Am after some advice on Packager Installs on OSX

Discussion in 'Parallels Mac Management for Microsoft SCCM' started by MartinJ6, Apr 3, 2019.

  1. MartinJ6

    MartinJ6 Bit Poster

    Messages:
    1
    We have a Package that we would Like to deploy to Our Macbooks Via SCCM
    The Package Requires a Directory to be Created and a File to be Copied - prior the the Application (I have built The Application and this bit Works Fine) being Installed.
    So I created a Package that Runs the Following Command
    mkdir -p "/Library/Application Support/OpenDNS Roaming Client/"
    This Package Works If I deploy It Independently
    I then Have a Second Package Which Runs This Command
    cp OrgInfo.plist "/Library/Application Support/OpenDNS Roaming Client/"
    Again this works fine providing the 1st Package/Command is Run
    What I wanted to do was Have a Job that runs one 1st before the Other
    With a Windows Deployment I would either use the "Run another Program 1st" option form the Advanced Tab of the 2nd Package.
    But doing this for an OSX deployment seems to fail
    So then I looked at doing it Via an OSX Task Sequence
    But When I Create an OSX Task Sequence and then Add/Edit the Install Package Option - though I can "Browse" to the Package and Select it - The "Program field remains empty and I cannot select a Program to run in the Task Sequence.

    Can anyone Point me in the correct direction to Achieve this please?
     
  2. TimofeyF

    TimofeyF Parallels Team

    Messages:
    29
    Martin,
    "Run another Program 1st" is not supported currently.
    I can suggest using a non-OSD Task Sequence with 2 steps installing your packages one after another.
     

Share This Page