Installing Gentoo on Parallels - eth0 not found

R

RomeoV

Bit poster
Hi

I've installed gentoo on a Parallels virtual machine. When i reboot the machine i didn't found eth0 but only lo

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 :: 1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)

How can i solve this problem? Is ther something module I've to compile in Kernel?

Thanks
 
I have the same problem. it is simple than that. just go to VM setting and pick a virtual network adapter type under advanced Settings..
but after that, for unknown reason, I have to run `dhcpcd enp0s5` every time I reboot the VM..
After spending a long time to figure out the graphic card stuff. I got everything work except parallels tools
 
You must log in or register to reply here.
Back
Top