Problem : Filtering with users and groups

  • Thread starter Thread starter Impuls
  • Start date Start date
I

Impuls

Hey,

I'm using 2x Application Server & Load Balancer version 5 (build 261)

2 * Terminal Server 2003 standard editions (with the agents on it)
1 * webserver with the gateway on it

Publishing an application is no problem and works fine.

But when I select filtering type 'user'
and select the 'Allow the following Users'
with Default Object Type : Users Only
and I select the user I want to grant the acces, the application
disappears from his client.

Is also tested it with a group, same scenario.

I tried different methods of logging on (upn, netbios, removing the domain in the client and setting the option in the console that they
have to use my domain or trusted domain)
With some methods not even allowing my user to log on.

Note that this software is running in the demo mode.

If this problem would be solved, then the purchase orde will be signed within the week from my chief.

Sincerly (& thx)

Impuls
Sunparks
 
Hi there,

Make sure that you only have filtering by user / group and ip and user filtering is not used. (For testing purposes).

Please updated your software to the latest version.
Nixu
 
Software is on latest version (no updates avaible)

In my test there's only filtering on user/group level.

no other filterings are applied.

If I don't get any respons by the end of the day, ill contact the
support department, cause I need to be sure that this works
before I buy the software.

Sincelry
Impuls
 
You must log in or register to reply here.
Back
Top