Problem running an application in Windows in Parallels

Discussion in 'Parallels Desktop for Apple Silicon (M1) Mac' started by JohnH63, May 2, 2021.

  1. JohnH63

    JohnH63 Bit Poster

    Messages:
    4
    Tried running my application in Windows after installing it, and was prompted with the message: "....detected there is a low amouont of system physical memory (24.3%) available which could lead to low system performance. ........."
    What steps should i take to remedy this ? This is the only app that i am running in Windows.
     
  2. MichaelH63

    MichaelH63 Kilo Poster

    Messages:
    190
    You can set the processor cores and RAM that Windows uses in the Parallels configuration settings. Set four cores and half your available RAM and see if that fixes your problem. Parallels shows you the recommended range and you might be able to use more, but half is usually a good setting.
     
  3. JohnH63

    JohnH63 Bit Poster

    Messages:
    4
    Yes it worked perfectly, much thanks for the help. This forum is really helpful.
     

Share This Page