PTC Creo on M1 Mac (ARM-based)

Discussion in 'General Questions' started by noah02, Apr 13, 2021.

Tags:
  1. noah02

    noah02 Bit poster

    Messages:
    2
    Hi,
    Is someone using ptc creo on his M1-Mac via Parallels? Is it working or are there any issues?

    Thanks for your response in advance!
     
    noah02, Apr 13, 2021
    #1
  2. MOUHSINES

    MOUHSINES Bit poster

    Messages:
    2
    I just tried now. It is not working. I could install creo8 on my M1-Parallels, with no errors/issues. But when i try to start Creo, nothing happens (no messages, etc.).
    In parallel, i installed and I am able to run SolidWorks.
     
    MOUHSINES, Oct 1, 2021
    #2
  3. LutherB

    LutherB Member

    Messages:
    32
    Check out this post: https://forum.parallels.com/threads/solidworks.353226/ The process illustrated there might help. I have heard of people running Creo without issue, so it's likely something you'll be able to fix.
     
    LutherB, Oct 1, 2021
    #3
  4. Maria@Parallels

    Maria@Parallels

    Messages:
    8,688
    Hi, if you tested it and got any issues please share the details here.
     
    Maria@Parallels, Oct 10, 2021
    #4

Share This Page