Unable to Edit Task Sequence

Discussion in 'Parallels Mac Management for Microsoft SCCM' started by RobertM25, Mar 23, 2017.

  1. RobertM25

    RobertM25 Bit Poster

    Messages:
    32
    I created a Task Sequence on PMM 5.0.2.20 and everything was working fine.

    I just upgraded to PMM 5.0.3.9 and now when I edit the Task Sequence and click "close," I receive the error:
    "Failed to commit task sequence

    Object reference not set to an instance of an object."

    If I try to create a new Task Sequence, I get:
    "Failed to run wizard

    Not found , property = ISVData"

    Any suggestions?
     
  2. Yury Averkiev

    Yury Averkiev Program Manager Parallels Support

    Messages:
    73
    Hi Robert, this looks like a bug. I suggest you to open a support ticket so the support team could gather some logs and pass those to the dev team.
     
  3. RobertM25

    RobertM25 Bit Poster

    Messages:
    32
    I figured it out. The first error was because I was connected to my CAS trying to edit it. When I connected the console to the primary site that owns the TS, it worked fine.

    The second error was due to an orphaned PMA-Proxy in AD that I deleted.
     
  4. RamL

    RamL Bit Poster

    Messages:
    5
    Can you describe how and where you found orphaned PMA Proxy in AD and deleted. I am asking because, I get same error.
    Ram
     
  5. RobertM25

    RobertM25 Bit Poster

    Messages:
    32
    I uninstalled a Primary Site without removing Parallels first.

    Went into AD to System > ParallelsServices > PmaConfigMgrProxy-SiteCode and deleted that entry.
     
  6. RamL

    RamL Bit Poster

    Messages:
    5
    Thanks Robert
     

Share This Page