brucknerdoc
Bit poster
After enduring the installation debacle this past weekend, I finally got PD8 to install. Had some problems with Windows 7 allowing me to log in, but after all was said and done, I could launch into W7 fine. I then went ahead and installed the preview W8 and all seemed to go well.
However, today I tried to launch PD8, and got an immediate crash (I've attached the crash log). Tried deleting some .plist files with no success.
I share the VM with VMWare Fusion and also recently upgraded that app to v5.x. It installed without any incidents and still runs my W7 VM just fine.
Getting a bit tired of all the problems PD8 has on my Mac - running ML 10.8.1...
Any suggestions to get PD8 to run again? Reinstall (again...)???
Thanks!
However, today I tried to launch PD8, and got an immediate crash (I've attached the crash log). Tried deleting some .plist files with no success.
I share the VM with VMWare Fusion and also recently upgraded that app to v5.x. It installed without any incidents and still runs my W7 VM just fine.
Getting a bit tired of all the problems PD8 has on my Mac - running ML 10.8.1...
Any suggestions to get PD8 to run again? Reinstall (again...)???
Thanks!