While I'm running parallels, I have been connecting a USB device that allows me to read instantaneous sensor values through another program, MotoTune. I used it on several Windows-based computers, and it works fine. I have the autoconnect feature enabled in parallels, so when I plug in the USB device, it is detected and begins to work. However, from time to time, the USB connection is lost, and I am unable to reconnect without a restart of the VM. This is really time-consuming and frustrating.
I've read on these forums that I could make a new bootcamp install, then make a parallels image from that, to have both options available (I would assume that this problem would not occur in bootcamp). But, I use parallels so much, as it is far easier to use than rebooting to Windows, I would rather not have to do that.
Does anyone know if there is a setting somewhere that I am overlooking that is automatically disconnecting the USB connection after a time-out or something?
I've read on these forums that I could make a new bootcamp install, then make a parallels image from that, to have both options available (I would assume that this problem would not occur in bootcamp). But, I use parallels so much, as it is far easier to use than rebooting to Windows, I would rather not have to do that.
Does anyone know if there is a setting somewhere that I am overlooking that is automatically disconnecting the USB connection after a time-out or something?