Search function here does not allow USB to be searched, it is too short!
Have read instructions for getting Windows under Parallel's Desktop to recognise a USB device, but cannot achieve it
There are two devices that need to connect
1 - A USB stick with software on it
2 - A communications interface that is used to connect the computer to a Paradox alarm panel. This needs a driver that is on the USB stick
In Windows, you run Winload and assign the USB port as the communication device, click "Connect" and off you go. With large and complicated alarm panels, this is the only way to program them, diagnose faults, read event history
On the MacBook, the USB stick is shown in Finder and also in System Properties
On the Control Panel of Parallels desktop, USB is ticked
Yet on Windows Explorer, the USB drive does not appear
Under Windows Device Manager, the USB part seems intact, showing no errors
Suggestions most welcome
Thank you
Have read instructions for getting Windows under Parallel's Desktop to recognise a USB device, but cannot achieve it
There are two devices that need to connect
1 - A USB stick with software on it
2 - A communications interface that is used to connect the computer to a Paradox alarm panel. This needs a driver that is on the USB stick
In Windows, you run Winload and assign the USB port as the communication device, click "Connect" and off you go. With large and complicated alarm panels, this is the only way to program them, diagnose faults, read event history
On the MacBook, the USB stick is shown in Finder and also in System Properties
On the Control Panel of Parallels desktop, USB is ticked
Yet on Windows Explorer, the USB drive does not appear
Under Windows Device Manager, the USB part seems intact, showing no errors
Suggestions most welcome
Thank you