PTC Creo - Won't run

Hello everyone I'm in your user of parallel deskopt, which I installed Creo on it. I have a problem that when I run creo nothing happened, so I read your conversation and it's impossible to modify the parametric.psf because I am not able to do it. so if someone can help me because I need to run on my Mac urgently! Thank you everyone one

 

Open the .psf file and edit it, then save a copy to your desktop (save as all types, and make sure it saves as .psf), then copy and paste the new version to the directory it should be in with overwrite privileges.

 

With content that I should modify in the .psf?
Can you give me a screenshot for the file ?
Thank you for help

 

I just want to say thank you so freaking much!! This was a life saver. I don't know much about this computer VOODOO stuff with scripts and what not. But Omg it worked!!! I cant thank you enough! (now do you know how I could get my ansys to work properly it says I need "OPEN GL >4.5")

 

I was able to install it but it works extremely slowly. any solution ?

 

I have the same problem and I don't know why. If we can run solidworks on it (refers to the specification on the website) that means Creo should work very well but it's not the case.
If someone have a solution to avoids the slowness ?

 

Do you find a solution ???

 

Hi, I tried this on the new M3 chip, and the workaround also works here so far (fingers crossed it stays that way)

 

Hi, i want to run Creo Illustrate and have the same problem but there is no paramteric.psf file to edit.
Have anyone a solution?

 

Hey guys, has anyone been experimenting around with this? I just got Creo running and open (make sure you restart after install and changing the parameters, or it'll never boot)... Needless to say, the advice above helped, but Creo is absymally slow, and seems to be running in 32-bit mode... Anyone know how to keep the ARM parameters, but kick it over to 64-bit?